A quieter van isn’t just more comfortable—it helps you stay focused on the job. That’s why installing DuraTherm Ceiling Liners for the Ford Transit Connect LWB are a top choice among commercial users. In this tutorial, we’ll guide you through the entire installation—from prep to final trim—so you can get it done in under an hour. Along the way, we’ll highlight key features like the reflective aluminum face, closed-cell foam core, and factory-cut precision that make this upgrade both efficient and effective.

Why Installing DuraTherm Ceiling Liners in Ford Transit Connect LWB Matters

First, bare sheet metal roofs amplify road noise. Moreover, heat gain drives up A/C use. Therefore, DuraTherm Ceiling Liners deliver:

  • Pre-cut Panels: Fit exactly to the Transit Connect LWB roof profile.
  • Dual-Layer Construction: Aluminum bonded to dense foam for thermal control.
  • Pre-scored Bends: Simplify fitting to roof contours.
  • Integrated Clip Holes: Use factory push-pins for fast attachment.

Consequently, your van stays cooler, quieter, and more professional.

Tools Required for Installing DuraTherm Ceiling Liners in Ford Transit Connect LWB

Before installing DuraTherm Ceiling Liners in Ford Transit Connect LWB, gather:

  • Trim-removal tools to clear factory foam blocks
  • Impact driver with Phillips bit for push-pin removal
  • Rubber mallet to seat liners into roof channels
  • Protective gloves to handle sharp aluminum edges

Meanwhile, park on level ground and clear the cargo area. This prep speeds the job.

Prep Steps: Clearing Factory Foam

Next, prep the roof cavity:

  1. Pry Out Foam Pads: Use trim tools to remove factory foam blocks.
  2. Vacuum Debris: Clear loose particles for a clean surface.
  3. Store Clips: Retain factory push-pins in a container for reuse.

Afterwards, test-fit the first liner panel to confirm clearance around wiring and light cut-outs.

Bending Edges Before Installing DuraTherm Ceiling Liners in Ford Transit Connect LWB

Now, ready each panel:

  • Locate Score Lines: Identify pre-cut bend points.
  • Fold Edges Inward: Gently crease along lines so panels hug the roof’s arch.
  • Tape Light Holes: Cover ceiling-light cut-outs to prevent debris loss.

Meanwhile, take care not to overstress panel corners.

Step-by-Step: Installing DuraTherm Ceiling Liners in Ford Transit Connect LWB

With prep done, install panels:

  1. Slide Into Channel: Tilt the forward edge under the headliner strip.
  2. Align Clip Holes: Center panel holes over roof cross-member slots.
  3. Insert Push-Pins: Push factory clips home until panels are snug.

Moreover, repeat this for the rear section. The included joiner strip snaps firmly between panels for a seamless appearance.

Securing Side Tabs and Fasteners

Once panels seat in place:

  • Install Side Clips: Use supplied plastic clips on folded edge tabs.
  • Clear Obstructions: Probe holes with a screwdriver to remove any foam debris.
  • Test Stability: Gently tug on liners to confirm firm retention.

Consequently, your ceiling liners remain locked under vibration.

Fitting Ceiling Sills for a Finished Look

For a polished result, install the aluminum ceiling sills:

  1. Match Sill to Roof Rail: Select “ceiling-sills: yes” pieces.
  2. Butt Against Liner: Align sill flange over the liner roof junction.
  3. Drive Self-Drilling Screws: Tap through sill and into underlying liner.

If holes misalign, drill a small pilot through the sill flange only.

Final Inspection After Installing DuraTherm Ceiling Liners

Finally, verify your work:

  • Check Seams: No light leaks at panel joints.
  • Confirm Clips: Every push-pin is flush.
  • Examine Sills: Aluminum rails run straight with no twist.

Afterwards, enjoy a hushed interior and improved thermal comfort.

Maintenance Tips for DuraTherm Ceiling

To keep liners pristine:

  • Dust With Microfiber: Wipe panels monthly to remove grime.
  • Spot-Clean Marks: Use mild detergent on scuffs.
  • Inspect Clips: Replace any broken push-pins after heavy use.

Altogether, simple care preserves both form and function.

Quiet, Cool, Professional

At Upfit Supply, we’ve seen how Installing DuraTherm Ceiling Liners upgrades both comfort and credibility. With factory-grade insulation and trouble-free installation, this mod is a must for any serious van upfit.

Ready for a quieter ride? Shop now:
DuraTherm Ceiling Liner for Ford Transit Connect LWB
Complete Transit Connect Upfit Package

Watch the full tutorial here: Installing DuraTherm Ceiling Liners in Ford Transit Connect LWB

With Upfit Supply, your van works as hard as you do—no exceptions.