I have a 2021 GMC Savana standard height 135in wb. I will start by saying something nice. The surface and thickness is good. I can not feel the floor ribs. I am still trying to flatten the matt with lumber. However the fit is poor. They could have made the matt a little wider. The cutout for the gas tank fill is tight and off center. The area by the side door requires a little trimming. This cut does not seem to go under the trim pieces on the side or rear doors. There is not enough material. The cut ends just show. There is no additional hardware of any kind. The biggest problem for me is the existing four D-ring tie downs on the floor. There is no cut out on the floor matt as mentioned in the videos. The D-rings are through-bolted to the frame with a nut. Removing them requires 2 persons and a large torx key. One above and one under the van. I would not suggest putting more than one screw hole in the matt to refasten the D-Rings after the matt is flat. I would not carve out a 2" hole in the 1/2" thick matt. I hope the walls fit better than the floor. Bye

Finished install of van tred cargo mat in 2007 Chevy express. It was cut to shape very well. Only had to do some cutting to finish fit it because the interior
walls had been insulated and covered with a custom wall cover that made it a little smaller floor space than the van tred was cut for. Interestingly my wife suggested that I use an old double bladed electric carving knife to cut the edges down to size. It worked quite well, probably are better ways but worked for me. July 28, 2024